|Hardware||1. Camera 2. Emitter 3. Mounts 4. USB cable (12m) 5. Ubi Pen 6. Power Adaptor 7. Tape/Screws|
|Calibration||Automatic(16 ms) / Manual (36 points)|
|Gestures||Tap, Swipe, Zoom, Pinch ( All Windows 10, 8 and 7 gestures)|
|Touch Points||Up to 20 touch points|
|Latency||< 30 ms|
|Accuracy||±1 Pixel (Resolution: 4096*4096)|
|Supported Screen Sizes ( diagonal)||Touch Kit: 40 inches to 80 inches
You can also have two 80″ displays side by side in an extended setup. Additional emitter needed.
|View angle ratio of the sensor||0.28,. Sensor to be installed 76cm/30 inches from the display surface|
|Wavelength of the IR emitter||940 nm|
|Power of IR Beam||150mw*2|
|Power Requirements for the emitter||3V/1.5A|
|Signal Refresh Rate||60 fps|
|Connections||The camera and PC are connected by USB Cable.
The emitter and sensor communicate wirelessly.
The emitter just needs power.
|Weight||0.5kg or 1.1 lbs|
|Dimensions||Emitter: 3.5cm x 17cm x 2.4cm|
|Supported OS||Windows 7, Windows 8/8.1/10|
|Minimum requirement of PC||32 or 64-bit Dual-core, 2.66-GHz or faster processor, USB 2.0 bus, 2 GB of RAM|